Genesis Site, Device and FT Configurations for Adpro Devicetype

Genesis Site, Device and FT Configurations for Adpro Devicetype

Adding a Site:
1. Click (+) to add a site


2. Provide Key properties like Name of the Site, and address details. Based on the availability of Site name, and its address, Location details will get auto filled:


3. Once the Site is successfully added in NXGEN, it will get synced with Talos on Site Category.

4. Inside the site, add a new device by selecting (+) button

5. Select Type as "ADPRO" and fill up the necessary parameters like Username, Password, Host address (IP/Domain), Control port, RTSP port and Server Unit ID.


6. Once Device got added, ensure the Alarm configuration for the device updated properly using Adpro Clients such as XO.

7. Open the device using the client Application

8. Navigate to System option


9. Navigate to Parallel Alarm Transmissions settings

10. Set the NXGEN Alarm Receiver Server IP (3.123.151.192) and IP Port (10000) in Parallel Transmission 1 Destination. Leave the CMS ID as default value.
Also set the Lifecheck configured to ensure the Site pulse report to the alarm server


11. Navigate to Alarm Profiles Behavior. Configure the KameraAlarm profile to ensure it camera alarms pushes events to Parallel Transmission 1:


Once All the above mentioned configurations are done, you can check the Site Pulse or Camera alarms in the Eventlogs of the respective sites in Talos.

    • Related Articles

    • Configuration Guide: Adding HikProconnect into Genesis.

      To integrate HikProConnect into Genesis, follow these steps: 1. Login into Genesis. 2. Navigate to Your Desired Site: Locate and select the specific site where you want to integrate HikProConnect. 3. Click on add: 4. Choose HikProconnect and add the ...

    • Hanwah Device Configuration issue

      ISSUE: When there is an issue related to adding a device, follow the below instructions. Firstly, check if the credentials shared are Basic & Digest authentication. To check, the following URL needs to be framed. http://[USERNAME]:[PASSWORD]@[IP ...

    • Teltonika-IOT Device Configuration

      Teltonika-IOT device Configuration. Add new device with device type Teltonika-IOT. Enable Periodic health check and Event polling. Edit Custom Alarm Rules. Device Edit > Additional Setting > Additional Property > Custom Alarm Rules. { "SolarCharger": ...

    • Talos - Genesis Bridge Plug-In

      Multi-monitor through Talos-Genesis plugin This document provides instructions for downloading the Talos Genesis Bridge, which is available as a browser extension for both Chrome and Edge. The extension serves as a bridge to link Talos Event ...

    • Requirements for creating new GENESIS VPN

      This document contains the necessary requirement details on the VPN Creation.